€45.00
GAZ 5IN1 235G R1234YF
GAS SET 5IN1 R1234YF, CAR AFTER 2017 + PRESSURE CABLE
Condition: New
Manufacturer: CarFix
Type of refrigerant: R1234yf
In Stock
*If you not find something, please ask about parts you need,availability and price.
facebook.com/groups/SubaruBalticMarket
www.facebook.com/SubieTime/
*We cannot guarantee 100% compatibility
Advantages of CARFIX:
High quality – a product that is 100% safe for the air conditioning system.
Easy to use – the application takes only a dozen or so minutes and requires only a hose with a pressure gauge, without the need for specialized tools.
Improvement of air conditioning – effectively supports the functioning of the system, even in extreme weather conditions.
Safety for the environment and users – contains natural hydrocarbon gas, harmless to vehicles and people using air conditioning.
Ecological composition – does not adversely affect the ozone layer.
Protection of components – does not cause corrosion or acid reactions in contact with moisture.
Additional compressor protection – contains synthetic grease that increases compressor efficiency and durability, improves lubrication and efficiently dissipates heat, minimizing the risk of failure.
INSTRUCTIONS FOR USING CARFIX GAS – IT’S REALLY SIMPLE:
✅ Preparation of the hose – in the valve with the needle, withdraw the needle as much as possible by turning the knob to the left.
✅ Connecting the set – connect the hose with the pressure gauge to the can.
✅ Air conditioning start – turn on the car engine and air conditioning (AC) in closed circuit mode, set the maximum power and the lowest temperature.
✅ Connection to the system – connect the hose with the pressure gauge to the low pressure valve (LP) in the vehicle and set the can with the valve down.
✅ Pressure measurement – check the pressure level in the system.
✅ Filling the system – turn the knob to the right so that the spire moves the check valve and allows gas to flow.
✅ Completion of charging – when the pressure gauge tip is in the green area (25 to 40 PSI), complete the process.
✅ Disconnecting the kit – disconnect the cable from the installation and screw the nut on the low pressure valve in the vehicle.
✅ Performance stabilization – leave the engine and air conditioning on (as in point 3) for a few minutes.
✅ Inspection after 2 weeks – check the pressure in the system again and repeat steps 5 to 7 if necessary.
Important information:
✅ Our pressure gauge cable only fits LP valve (11mm), so there is no risk of misconnection.
✅ If you cannot find the LP port in your car, you may need to purchase an adapter.
